|
|
| | Design |
|
|
| 
|
|
Monitoring equipment
All these pumps have temperature sensors in their windings and main bearings. Should liquid penetrate a pump's stator housing, a float-switch sensor positioned below the bearings and the stator-end coils will shut the pump down. Additional monitoring functions can be installed.
Approvals
All the pumps are approved in accordance with national and international standards (IEC 34-1, CSA). They are also available in explosion proof versions: Factory Mutual (FM) and European Norm(EN).
Corrosion protection
For corrosive applications, all these pumps can be equipped with zinc anodes, extra corrosion-resistant outer seal, epoxy coating, and stainless shaft and impeller.
Motor
Squirrel cage, high-performance, induction motor, specially designed for submersible applications and manufactured by ITT Water & Wastewater.
Bearings
Designed with one roller bearing and one or two angular-contact ball bearings.
Seals
Two sets of mechanical shaft-seals that work independently for double security. Designed, patented, and manufactured by ITT Water & Wastewater.
Oil housing
In addition to lubricating the seals, the oil-filled compartment dissipates heat from the motor and bearing. The housing also provides additional safety against penetration by liquids.
Wear rings
Easily replaced wear rings help maintain high pumping efficiency.
|
|
|
|
|
| ![]()
| ![]()
|
|
Products
